100% Brand New and High Quality
Material: Metal + Plastic
Rated Voltage: Dc 12v
Rated Power: 60w
Maximum Flow: 5l/Min
Maximum Pressure: 0.8mpa
Pump Diameter: Approx. 5 Cm / 1.97"
Length: Approx. 16cm / 6.3"
Cable Length: Approx. 60cm / 23.62
Clips Length: Approx. 8cm / 3.15"
Outlet Pvc Pipe Length:150cm
Nylon Pipe Length:100cm
Quantity: 1 Pc
How to Use: Start to Run the Car Engine for a While, When Oil Temperature Turns to Be About 50 Degrees, Start Pumping Oil
Connect the Pump to the Power, Run It for a While, and Observe Whether the Inlet and Outlet Is Normal
Open the Filler Cap,Get Dipstick out, Force the Tube into the Bottom of the Joint, Until the Tube Does Not Move
Then Put the Inlet Pipe from the Oil Dipstick into in End (the Tube into the Bottom of the Tank, the Bottom Concave Place, in Order to Pump the Oil Completely)
As No Oil or Pumping up Very Slowly or Intermittently, It Is Generally Caused by Loose Pipes and Fittings. You Have to Install the Pipes and Fittings Again.)
After Oil Pumping, Remove the Tube, and Then Run the Pump for a While, Pump the Remaining Oil Inside the Pumping Clean, or Pump Water for a While Until the Pump Head Gets Clean
If You Have Not Used It for a Long Time, It May Have No Suction, Then Just Pour the Water in the Pump, and Run the Pump for a Few Minutes Until the Air Is All out
What Is Included:
1x Oil Pump
1x 11mm Outlet Pvc Pipe
1x 6mm Nylon Pipe
Note: This Pump Cannot Pump Corrosive Liquids Such As Gasoline and Diesel, but Can Only Pump Non-corrosive Liquids Such As Engine Oil, Water, Lubricating Oil, Etc.